9
8
Toy Assembly Stage 2 Seat Assembly
Allow only the baby’s toes to touch the floor. DO NOT
allow the baby to stand flat-footed on the floor. As baby
grows and becomes more active, raise the tray to the
next level so that baby enjoys the most comfortable fit
and maximum use of the spin and bounce features.
To adjust height:
ALWAYS remove baby from ExerSaucer
®
before adjusting.
Push the button
N> !
until the desired position is obtained.
Make sure that all four legs are adjusted to the same position.
Attach toys by routing Velcro® straps
V
through slots in tray
and fastening underneath. Pull up on the installed toys to
make sure they are secure.
To remove toys, unfasten Velcro® straps from underneath tray
and remove toy.
To install stalk toys, press firmly into tray as shown.
Pull up on stalk toys to make sure they are locked
in place.
To remove stalk toys, squeeze tabs
W
and lift stalk
toys from tray.
N1
WARNING
ON/OFF
Batteries
Batteries
Batteries
ON/OFF
ON/OFF
Remove
V
W
To Next Page
Loading...
Need help?
General
