23
• The carrier MUST be locked rmly into the
convenience base. Check by lifting up on the carrier.
• NEVER use the vehicle seat belts when using the
lower anchor connector. Using both together can
cause slack in a sudden stop or crash.
• This child restraint MUST face the
rear of the vehicle.
• NEVER use this child restraint in
the forward-facing position.
• Check your vehicle owner’s
manual to determine how to lock
your seat belt for child restraint
installation. The seat belt MUST be locked to properly
secure the child restraint.
WARNING!
DEATH or SERIOUS
INJURY can occur.
Installing the Convenience Base
with the Vehicle Seat Belt
Secure the convenience
base to your vehicle
seat by routing the vehicle
seat belt through the
openings as shown, then
buckle the seat belt.
LAP BELT
LAP/SHOULDER
BELT
1
IMPORTANT: Some ELR vehicle belts can be switched
into locking mode for child restraint installation. It may
not be necessary to use a locking clip in these situations.
To install a locking clip, refer to page 44.
Refer to the vehicle owner’s manual to determine which
type of belt retractor is in the vehicle.
Before you begin, be sure the vehicle is on a
level surface.
A
R
M
P
I
T
L
E
V
E
L
To Next Page
Loading...
