Evenflo NurtureMax - Placing the Carrier in the Base (Continued); Adjusting Base Recline; Handle Position for Travel; Releasing the Carrier from the Base

26
If level line is not level with the ground, use a tightly
rolled towel, or small blanket, beneath the front
edge of the base, in order to provide enough recline
for an infant’s head to lie back comfortably.
IMPORTANT: Infants may have difculty breathing when
in a sitting position. Make sure they recline enough for
their head to lie back comfortably and safely. Failure to
properly recline the child restraint could increase the
child’s risk of serious injury or death.
2
With the handle in
Position 1, squeeze the
base release lever on the
back of the child restraint,
rotate rear of seat up and
out of base, then lift the
carrier out.
4
1
Push down and rotate
the handle to the
desired position until
it locks into place.
ALWAYS place the
handle in Position 1
or 3 while traveling in a
vehicle (page 18).
Placing the Carrier in the Base
Releasing the Carrier from the Base
1
3