44
Thread the seat
belt through the base
(or child restraint) and
buckle the seat belt.
1
If your vehicle was built prior
to model year 1996, and
has a lap/shoulder belt that is
equipped with an emergency
locking retractor (ELR) AND
sliding latch plate, you MUST
use a Locking Clip. Check
your vehicle owner’s manual
to identify which vehicle belt
system is in your vehicle and
contact ParentLink to obtain a
Locking Clip. If your vehicle is
model year 1996 or newer,
it likely has a vehicle belt system that can be locked
when tightened, and will not require use of a Locking
Clip. Consult your vehicle owner’s manual before
installing a Locking Clip.
Locking Clip
installed
properly.
13 mm
(0.5 in.)
Using a Locking Clip
Push down on the base
while pulling the shoulder
belt tightly to remove all
slack from the lap portion of
the belt.
2
Hold the lap and
shoulder belts together
just behind the free
sliding buckle tongue and
unbuckle the seat belt.
3
To Next Page
Loading...
