Evenflo NurtureMax - Changing the Harness Position (Continued); Inserting Harness Strap into New Slot; Securing Harness Strap on Splitter Plate; Tightening Harness Straps

38
4
Changing the Harness Position
Insert harness strap into new harness position slot.
IMPORTANT: When inserting harness straps
through the slots in the seat pad, make sure you
route them correctly through their corresponding
slots in the seat shell.
5
6
Make sure the harness strap is installed completely
on the splitter plate as shown, then repeat steps
2-5 for other side.
Tighten the harness straps by pulling the
adjustment strap on front of the restraint.
NOTE: Final adjustment of the harness straps must
be completed with the baby in the child restraint.