20 21
Using with the 5-pt Harness
5.
Connect and tighten
Tether Strap.
Connect the Tether Hook
to the anchor behind
the vehicle seat, as
shown. (Please consult
your vehicle owner’s
manual, as tether anchor
locations may vary.)
Pull the strap and tighten
the Tether securely.
Notice
Your child restraint is equipped with one of two types of
tether adjusters: standard (shown above) or the TruTether
(shown below). If your child restraint is equipped with the
TruTether adjuster, refer to page 44 for information about
proper tightening.
TruTether Adjuster
Tightness Indicator
Display
Installation with SureLatch ConnectorsInstallation with SureLatch Connectors
4. Secure the child
restraint.
Using your full weight,
push the child restraint
firmly into the vehicle
seat
, as shown, to set it
in place.
Upper
Belt Path
IMPORTANT: To properly secure this child restraint, it
MUST NOT move more than 25 mm (1 inch) from side-
to-side or from front-to-back at the upper belt path.
If you can not tightly secure the child restraint, try again,
move it to another location, or install with vehicle seat belt.
Make sure that each SureLatch
connector is above the LATCH
guide, as shown.
LATCH
Guide
IMPORTANT: If your tether strap is too short to reach from
your child restraint to your vehicle tether anchor, you will need
a Tether Extender. Please call
ParentLink at 1-800-233-5921
(U.S.) or 1-937-773-3971 (Canada), or 01-800-706-12-00
(Mexico).
To Next Page
Loading...
