42 43
General Information
Canadian Models Only
Leveling the Booster Seat
Using the SureLatch Connectors
To remove the SureLatch
Connector from a LATCH
anchor or a storage D-ring,
press the red Release Button.
Release Button
If the level line is not
parallel to the ground,
before fastening child to
the vehicle seat, place
a tightly rolled towel/
small blanket beneath
the bottom rear of the
booster seat, as shown.
Towel/Small Blanket
Level Line
Canadian models:
Only the lap belt must pass under the
guide & fasten into the buckle.
US models:
When used with a child that weighs
18 - 29.4 kg (40 - 65 lbs) both
the lap belt and the shoulder
belt must pass under the guide
& fasten into the buckle.
When used with a child that
weighs 29.4 - 49.6 kg
(65 - 110 lbs) only the lap belt
must pass under the guide & fasten into the buckle.
Booster Seat Belt Routing
Using the Quick Connectors
To remove the Quick Connector from a LATCH anchor or
a storage D-ring, pull the red Release Strap.
Release Strap
Using the Latch Hook Connectors
To remove the Latch Hook
Connector from a LATCH
anchor or a storage D-ring,
press the tab and twist,
then remove the hook.
Tab
To Next Page
Loading...