Secure the carrier to the
base by placing it into
the base and pressing
down on the front and
back.
The carrier MUST be
locked firmly into the
base. Check by lifting
up on the carrier handle
or the front of the
carrier to make sure it is
locked in place.
1
25
Make sure the lap belt is tight. Grab the base at the
areas
I
, as shown. If you can move the base more
than 25 mm (1 inch) forward or side-to-side the lap
belt is not tight enough. You will need to try again, or
find another location for your
convenience
base.
Route any excess lap belt through the openings F
on the sides of the base so it does not interfere
with the metal carrier retainers J when attaching
the carrier.
F
J
4
I
WARNING
Placing the Carrier in the Base
Ä
To Next Page
Loading...
