Evenflo Snugli - Installation: With Vehicle Seat Belt; Seat Belt Installation Steps

Installing the Convenience Base
with the Vehicle Seat Belt
WARNING
1
B
A
C
D
•ThecarrierMUST be locked firmly into the con-
venience base. Check by lifting up on the carrier.
•NEVER use this child restraint in the forward-facing
position.
• DO NOT use this child restraint rear-facing in a vehicle
equipped with lap belts that only lock during a sudden
stop or crash (emergency locking retractor – ELR). You
must use a seating location with a locking seat belt.
Check your vehicle owner’s manual to see if you have
lap belts with ELRs.
Before you begin, be sure the vehicle is
on a level surface.
The base is level when only green (no red) is
showing in the level indicator window.
If the indicator is red,
adjust the level of the base
by pressing adjustment
button C and lowering
the adjustment foot D.
Note: The adjustment foot
has multiple levels.
23
Place the base A on the
vehicle seat and check the
level indicator B.
Tip!
Tip!
IMPORTANT
Not all models are equipped with an adjustment foot. If
your model does not have one, use a rolled-up towel to
adjust base level (p. 26).