Even-GLO™ Series GA301
Page 18
October-28-15
Portable Models (GA301M & GA301MP)
Secure Pole Neck to Pole
a) Slide Bottom Housing Assembly down Pole
b) Place Pole Neck in Pole, Line-up the 4 holes, place Button Socket Cap Screws into
holes and place Internal S.S Lock Washer over threads inside Pole and hand
tighten Nylon Insert Brass Nuts
c) Tighten Nut with Wrench while making sure Button Socket Cap Screw is properly
secured and not spinning.
To Next Page
Loading...