Introduction
This manual covers the operation of the Genesis Spark kiln controller. The Genesis Spark is a
versatile touch screen controller that regulates the temperature in your kiln so you can fire a
variety of products like ceramics, glass, jewelry, and more. The Genesis Spark has preset
ceramic programs with cone fire programming, preset glass firing profiles, and 30 custom
programs, along with Wi-Fi capabilities for software updating, built in diagnostics, and
maintenance logging among other new features.!
Precautions
• The controller is used to control temperature; it is not a safety device.
• Do not operate the controller in temperatures above 160˚F.
• Always supervise your kiln during a firing.
• The controller contains electronic components which are sensitive to static electricity.
Before handling the controller dissipate any static charge you may have by touching metal or a
screw on the controller panel, the electrical box, the kiln lid, or some other grounded object.!
• Always check the position of the thermocouple probe before starting a firing. The current
temperature displayed on the controller is measured at the end of the thermocouple which
must be in the firing chamber about 1” to 1-1/2”. Seal the opening around the thermocouple
with kaowool or similar material if necessary.!
• Always review the current program before firing to ensure the correct profile is
programmed.!
• Ensure the kiln and the areas around the kiln are clear of combustible material. See kiln
manufacturer’s recommendation on required clearances.!
First Firing of the Kiln
The purpose of the first firing is to put a protective oxide layer on the elements and
thermocouple. The first firing is done without ware in the kiln that might give off fumes that
contaminate the elements. It should be done according to the kiln manufacturer’s
specifications. Consult your kiln manufacturer for questions on the first firing of the kiln.$
To Next Page
Loading...
