Menu
Press this button to see all of the menu sub-items in order to view, adjust and configure your
controller.!
Data Menu
The Data Menu holds 3 types of information: diagnostic, status, and kiln information. !
Last Firing Status!
Contains diagnostics information specific to the last firing of the kiln.!
Last Error Status!
Contains diagnostic information specific to the last error that was encountered by the
controller when firing.!
Last Manual Diagnostics!
Contains diagnostic information from the last manual diagnostics test. This includes line
voltage readings, and board output.!
Factory Diagnostics!
Contains diagnostic information from factory. This includes line voltage readings, and board
output. This information can be used for comparison when a manual diagnostic test is run!
Last Element Change!
Contains diagnostic information from the last new elements diagnostics. This includes line
voltage readings, and board output.!
Export Log Files!
Used to activate Server Mode. This allows the controller to “serve” a file to a computer/
phone that is on the same access point as the controller. When “Export Log File” is pressed,
the controller will list an IP address and a code. Type the address listed on the controller into
your internet browser and then enter the code when prompted.!
The last 10 firings will be listed and each firing has 2 files – the temperature data and the
event file. The temperature file collects data every 30 seconds. The event file collects data any
time an “event” occurs such as a hold or an error occurs. Click on the file to be observed to
download it.!
Kiln Info!
Contains the firmware version plus the serial number and mac address for registering and
viewing your kiln at www.bartinst.com. Updating firmware will NOT affect the firing programs.!
To Next Page
Loading...
