If some of the left four program lights are blinking fast, your dishwasher is indicating that it is out of order
("Error code), please turn off the main power and water supply before calling for a service.
15
NOTE:
Forget to Add a Dish?
A forgotten dish can be added any time before the detergent cap opens.
Press the “START / RESET” button to pause the dishwasher.
Wait 10 seconds for the spray arm to stop spraying then
open the door.
Add forgotten dishes.
Close the door , the
dishwasher will continue to run after 10 seconds.
Pause button/and press the Start
4
3
2
1
The program lights indicate the state of the dishwasher:
ll of the program lights off
) Some of the left four program lights blinking fast -->error
a) A --> stand by
b) One of the program lights on --> pause
c) One of the program lights blinking slowly --> run
d
TURNING ON THE APPLIANCE
Change the Programme
Please press the Start/Reset button and hold for more
than three seconds, this will cancel the current
programme; or turn off the appliance by pressing the
on/off button to cancel the current programme.
Turn the programme knob to select the desired
programme.
Press the Start/Pause button to begin the wash.
1
2
3
Premise: A cycle that is underway can only
it has been running for a short time. Otherwise, the
detergent may have already been released, and the
appliance may have already drained the wash water. If this
is the case, the detergent dispenser must be refilled (see
the paragraph entitled “Loading the Detergent”).
be modified if
NOTE: If you open the door when washing, the machine
will pause. When you close the door and press the
Start/Pause button, the machine will continue to work
after 10 seconds.
Starting a wash cycle. . .
3
4
5
6
7
8
1
Draw out the lower and upper rack, load the dishes and
push them back in. It is recommended to load the lower
rack first, then the upper one (see the section entitled
“Loading the Dishwasher”)
Pour in the detergent (see the section entitled,
Detergent and Rinse Aid”).
Press the ON/OFF button
Turn the knob located on the right of the control panel in
a clockwise direction until it reaches the number or the
symbol for the cycle selected.
Press the Start/Reset button to start the washing.
When the washing is over, you can shut off the unit by
pressing the on/off button.
To ensure the door is properly closed.
2
Ensure there is power to the dishwasher and Make
sure that the water supply is turned on to full pressure.
It is dangerous to open the door when washing as the hot water and steam may scald you.
WARNING!
Open the door carefully. Hot steam may escape when the door is opened!
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
15 minutes before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes.
This will ensure they will cool down and assist with the drying.
It is normal that the dishwasher is wet inside.
Empty the lower rack first and than the upper one. This will avoid water dripping from the
upper rack onto the dishes in the lower one.
NOTE: A click should be heard when the door is
closed correctly.
Unloading the dishwasher
To Next Page
Loading...
