6
How to Drain Excess Water From Hoses
If the sink is 1000mm above the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable
container that is held outside and lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, observe to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Syphon Connection
The waste connection must be at a height of between 40 cm (minimum) and 100 cm (maximum)
from the bottom of the dish. The water drain hose should be fixed by a hose clip.
Before starting the dishwasher
The following should be checked before starting the dishwasher.
1 Whether the dishwasher is level and fixed into position.
2 Whether the inlet water valve is opened.
3 Drain hose connected has the plug in waste tee been opened for drainage.
4 Whether there is leakage at the hose conections.
5 Whether the power cord is connected and power switched on.
6 Whether the inlet and drain hoses are kinked (as per page 4).
7 All packing materials and printings should be taken out from the dishwasher.
8 Can the spray arms rotate freely.
To Next Page
Loading...
