20
Before calling for service . . .
Problem Possible Causes What To Do
Cloudiness on
glassware
Combination of soft
water and too much
detergent
Use less detergent if you have soft water and select
shortest cycle to wash the glassware and to get them
clean.
Yellow o r b rown f ilm
on inside surfaces
Tea or coffee stains
using a solution of 1/2 cup of bleach and 3 cups warm
water to remove the stains by hand.
WARNING
You have to wait for 20 minutes after a cycle to let the
heating elements cool down before cleaning interior;
otherwise, burns may occur.
Iron deposits in water
can cause an overall film
You have to call a water softener company for a special
filter.
White film on inside
surface
Hard water minerals
To clean the interior, use a damp sponge with dishwasher
detergent and wear rubber gloves. Never use any other
cleaner than dishwasher detergent for the risk of foaming
or suds.
Dial is not in the OFF
position
Turn the Dial to OFF position and slide the door latch to
the left.
Detergent left in
dispenser cups
Dishes block detergent
cups
Re-loading the dishes properly.
Steam
Normal phenomenon
There is some steam coming through the vent by the
door latch during drying and water draining.
Black or gray
marks on dishes
Aluminum utensils have
rubbed against dishes
Use a mild abrasive cleaner to eliminate those marks.
Detergent cup lid
won t latch
'
Water standing in
This is normal A small amount of clean water around the outlet on
the tub bottom keeps the water seal lubricated.
the bottom of the tub
Dishwasher leaks
Be careful not to overfill the rinse aid dispenser.
Spilled rinse aid could cause oversudsing and lead
to overflowing. Wipe away any spills with a damp cloth.
Make sure the dishwasher is level.
Overfill dispenser or rinse
aid spills
Dishwasher isn t level
'
WARNING!
If overflow occurs, turn off the main water supply before calling for a service. If there is water in the base pan because
of an overfill or small leak, the water should be removed before restarting the dishwasher.
ERROR CODES
Longer inlet time.
Water supply off or not sufficient.
The drying light brighten up
simultaneously
Codes
Issue
Possible Causes
Longer heating time,
but not reaching required
temperature
Malfunction of temperature sensor or of heating
element.
Overfilled.
Too much inlet water. .
Failure of temperature sensor
Short circuit or break of temperature sensor
Open circuit or break of temperature sensor
Failure of temperature sensor
The light and drying light brighten
up simultaneously
rinse
The wash light brighten up
simultaneously
The wash light, rinse light and drying
light brighten up simultaneously
The wash light and rinse light brighten
up simultaneously
Moisture on
exterior panels
This is normal climatic
conditions
Remove moisture with a soft dry cloth
To Previous Page
Loading...
