5
Electrical Requirements
Electrical Connection
DO NOT USE EXTENSION LEAD OR AN ADAPTOR PLUG WITH THIS APPLIANCE.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD GROUNDING PRONG FROM THE POWER
CORD.
CAUTION,
for personal safety:
Electricity
After making sure that the voltage and the frequency values for the current in the home correspond to those on the
rating plate and that the electrical system is sized for the maximum voltage on the rating plate, insert the plug into
an electrical socket which is earthed properly. Do not use adaptors to manipulate incompatible sockets.
Please see the rating label to identify the rating voltage and connect the dishwasher to appropriate power supply,
Please use the required fuse 12 amp. Fused electrical supply is required - copper wire only. Time delay fuse or circuit
breaker recommended and provide separate circuit serving specifically for this appliance. The Outlet should be placed
in an adjacent cabinet.
Ensure appropriate ground is evident prior to use
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event
of a malfunction or breakdown, grounding will
reduce the risk of electric shock by providing a
path of least resistance of electric current. This
appliance is equipped with a cord having an
equipment-grounding conductor and a grounding
plug. The plug must be plugged into an appropriate
outlet that is installed and grounded in accordance
with all local codes and ordinances.
WARNING!
Improper connection of the equipment-
grounding conductor can result in a risk
of electric shock. Check with a qualified
electrician or service representative if you
are in doubt whether the appliance is
properly grounded. Do not modify the plug
provided with the appliance; If it is not fit for
the outlet. Have a proper outlet installed by a
qualified electrician.
n
n
Cold Water Connection
Connect the cold water supply hose to the inlet connector and make sure that it is fastened
tightly in place. If the water pipes are new or have not been used for an extended period of
time, let the water run to make sure that the water is clear and free of impurities. If this
precaution is not taken, there is a risk that the water inlet can get blocked and damage the
appliance.
Hot Water Connection
The water supply to the appliance can also be connected to the house hot water line
(centralized system, heating system),as long as it does not exceed a temperature of 60° C.
In this case, the wash cycle time will be shortened by about 15 minutes and the wash
efficiency slightly reduced. The connection must be made to the hot water line following the
same procedures as those for the connection to the cold water line.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind it,
and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply
and drain hoses that can be positioned to the right or the left to facilitate proper installation.
To Next Page
Loading...
