EASY DECISION
ACCESSORIES
This appliance is supplied with one wire rack and a deep baking tray with wire tray insert. It is recommended
that you use the containers indicated depending on the food you will cook in your oven. You can also use
glass containers, cake pans and special oven trays suitable for use in your oven (available in kitchenware
shops). Pay attention to the information given by the supplier for use of this cookware. The information given
below should be implemented for enamelled containers.
If the food to be cooked does not completely cover the oven tray, if the food is taken out of the deep-freezer
or if the tray is used to collect the dripping juices of the foods during the grill operation, deformation might be
observed on the tray over time due to high temperatures forming during the cooking/baking operation. This is
a normal, physical state that results during the heat transfer. Do not leave a glass tray or container in a cold
environment immediately after cooking in them. Do not place them on cold and wet surfaces. Ensure that
they slowly cool off by placing them on a dry piece of cloth or wooden board, otherwise, the glass tray or
container might break. If you are going to use your oven to grill, we recommend using the large wire shelves
at the higher level, and inserting a tray into one of the lower shelf positions to collect fat or oil. To make
cleaning easier, add some water into this tray. In a grilling operation, use the shelf in the top positions.
When you first run your oven, a certain smell will be emanated arising from the insulation materials and the
heater elements. For this reason, before using your oven, run it empty at maximum temperature for 45
minutes. At the same time you need to properly ventilate the environment in which the oven is installed.
In order to cook in your oven, the oven function and temperature setting controls need to be adjusted and the
oven timer needs to be set, otherwise, the oven will not operate.
Protect your appliance from atmospheric effects. Do not install where it can be affected by the sun, rain, snow,
dust etc.
FITTING THE SHELVES
Each shelf has a stopper built-in as a reminder when pulling the shelf out. To fit a shelf, push back (lift
slightly when the stop engages) into the shelf position built into the sides of the oven. To remove the shelf,
pull forward, and then lift slightly as the stop engages.
CLEANING
The appliance should be disconnected from the power outlet or turned off at your isolation switch
before commencing any cleaning process.
Cleaning the oven exterior:
Before starting to clean your oven, be sure that all control buttons are off and your appliance has cooled
off. Unplug the appliance. Do not use cleaning materials containing particles that might scratch the
enamelled and painted parts of your oven. Use cream cleaners or liquid cleaners, which do not contain
particles. As these cleaners may damage the surfaces, do not use caustic creams, abrasive cleaning
powders, rough wire wool or hard tools. In the event of any excess liquids spilling over your oven surface
during cleaning, clean up immediately so as to prevent possible damage to the enamel or metal surface.
Do not use steam cleaners for cleaning the oven.
Cleaning the interior of the oven:
Make sure to unplug the oven (or fully disconnect from the power source) before starting to clean it. You
will obtain best results if you clean the oven interior while the oven is slightly warm (the oven should not
be operating). Wipe your oven with a soft piece of cloth (e.g. dish cloth) dampened with warm soapy
water after each use, rinse cloth in warm water then wipe oven again and then finish by wiping with a dry
cloth. For a complete cleaning process, use dry and powder type oven cleaners, following the oven
cleaning product’s instructions. Failure to clean the appliance properly & allowing fat & grease to build
up can potentially cause a fire hazard.
12
To Next Page
Loading...
