Everdure OBEGS601 - Installation

EASY DECISION
INSTALLATION
The adjacent furniture must be able to withstand a minimum temperature rise of 110°C above
the ambient temperature of the room it is located in, during periods of use. The power supply
to the appliance must be cut off before any adjustments or maintenance work is done on it.
PREPARATION FOR INSTALLATION AND USE
Manufactured with best quality parts and materials, this modern, functional and practical oven will meet
your needs in all respects. Make sure to read the manual to obtain successful results so as not to
experience any problems in the future. The information given below contains rules that are necessary for
correct positioning and service operations. They should be read without fail, especially by the technician
who will position the appliance.
CHOOSING A PLACE FOR THE APPLIANCES
There are several points to pay attention to when
choosing a place for your oven. Make sure to
take into account our recommendations below in
order to prevent any problems and dangerous
situations, which might occur later!
When choosing a place for the oven, attention
should be paid that there are no flammable or
combustible materials in the close vicinity, such as
curtains, oil, cloth etc. which quickly catch fire.
Furniture surrounding the oven or cooktop must
be made of materials resistant to temperatures
above 110 C°.
Required changes to wall cabinets and exhaust
fans above a built-in cooktop as well as minimum
heights from the oven board are shown in the
diagram. Accordingly, a range hood should be at a minimum height of 65 cm from the cooktop. If there
is no range hood the height should not be less than 70 cm. Refer to the range hood / cooktop instructions
for specific details before installation.
INSTALLATION OF BUILT IN OVEN
Insert the oven into cabinet pushing it forward fully. Open
the oven door and insert 4 screws into the holes on insides
of the oven frame and attach to the cabinet.
The dimensions and material of the cabinet in which the
oven will be installed must be correct and resistant to
increases in temperature. In a correct installation, contact
with electrical or insulated parts must be prevented.
Insulating parts need to be fitted in a way to ensure that
they cannot be removed by using any kind of tool.
Installing the appliance in the close vicinity of a
refrigerator or a deep-freezer is not recommended as the
performance of the above-mentioned appliances will be
negatively affected due to emanating heat. After
removing your oven from its packaging, be sure that the oven is not damaged. If you suspect any
damage to the appliance, do not use it; immediately contact an authorised Service Centre.
6