EASY DECISION
APPLIANCE DETAILS
ELECTRICAL DETAILS:
OVENS:
Rated Voltage: 220 to 240 Vac 50 Hz
Max Rated Inputs: OBEGS601, OBEGS602: 2000W,
Supply Connection: OVENS - 10A plug.
This information can be found on the rating plate (data label) affixed to the inside of the door jamb.
SIZES:
Note: Depth not including handle or power cord & plug.
POWER USAGE:
GRILL ELEMENT: 1600W
REAR OVEN ELEMENT: 2000W
OVEN LIGHT: 25W
ELECTRICAL CONNECTIONS
LOCAL AUTHORITY REQUIREMENTS
Installation by a licensed electrician is recommended and must be carried out according to
instructions provided by the manufacturer. Incorrect installation might cause harm and damage
which the manufacturer accepts no responsibility.
ELECTRICAL INSTALLATION FOR THE LICENSED ELECTRICIAN
This oven must be connected to a 220-240V 50Hz power supply. It is earthed via the 10Amp plug and
supply cord.
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on
the appliance identification plate) must be checked for correspondence to the available mains supply
voltage, and the mains electric wiring should be suitable for the oven’s power rating (also indicated on the
appliance identification plate). Use a suitable electrical cable (wires minimum area1.5mm²) and plug if
necessary.
The switched outlet must be connected to a suitable earth wiring, in conformity to current safety
regulations.
This appliance must be plugged into a 10A switched outlet. It should not be located above the appliance
and no more than 1.25m away from it. The power supply cord must not touch against any hot surfaces and
must be placed so that its temperature does not exceed 75°C at any point along its length.
After having installed the appliance, the switched outlet must always be in an accessible position.
NOTE: For connections to the mains power supply, never use adapters, reductions or multiple power points
as these may overheat and catch fire.
The mains terminal block is located on the back of the oven and the terminals are accessible by opening the
terminal block cover. Note: The back panel or terminal cover should not be opened when the mains power
is still connected to the appliance and never by an unauthorised person.
The electrical safety of this appliance can only be guaranteed if the oven is correctly and efficiently earthed.
The manufacturer declines all responsibility for damage resulting from an installation which has not been
earthed correctly.
The use of adapters, multiple sockets and/or extensions, is not allowed.
Relevant Sizes: WIDTH (mm) DEPTH (mm) HEIGHT (mm) CAPACITY (L)
External Oven size 598 575 598 77
4
To Next Page
Loading...
