6
CLEANING
SAFETY PRECAUTION
Before cleaning your rangehood or performing any maintenance, please ensure that the range hood is turned
off at the power point.
Do not use abrasive cleaners to clean the range hood. The use of warm soapy water and a cloth is
recommended.
Ensure that the range hood is cleaned regularly, as a build-up of grease and fat may occur otherwise.
The filters on the range hood must be cleaned regularly to maintain efficiency, and prevent grease build up.
The filter mesh is made of metal. It is recommended that this is undertaken every 4 – 6 weeks, depending on
frequency of use. The filters can be cleaned with warm soapy water or a cloth.
Cleaning of the range hood must be performed as described above; otherwise there is a possibility of a fire
hazard due to grease and fat build up.
REPLACING THE LIGHTS
1. Before changing the lights, make sure that the appliance is unplugged from the power source.
2. Remove the grease filter.
3. Press the spring splinter of both sides of the LED light until the light is released (see image below).
Lightly pull the light connecting wire out, and dismantle the terminal of the light connecting wire.
4. Reverse the procedure to install the new 12V DC 1.5W MAX LED light.
To Next Page
Loading...
