EasyManua.ls Logo

Everdure UFGS69 - USING THE HOBS

Everdure UFGS69
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DESIGNED TO PERFECTION
USING THE HOBS
Note: The control knob decals are printed on the bezels at the
base of each control knob.
The hobs of the appliance are each controlled via a knob on the
control panel. Each burner is represented by a filled in rectangle
on the decal just above the control knob.
LO : Heat maintenance position.
MED : Heating in low temperature position.
HI : Cooking, frying and boiling position.
Position the control knob so the indicator is pointing upwards (off).
Press the control knob in and rotate the control knob anti-
clockwise to the HI position. Press the ignition button (to the left of
the control panel) to ignite the gas. Once the gas ignites, hold the
control knob in for a few seconds to allow the flame to stabilise,
and then release and adjust to the desired setting. If the gas does
not ignite, return to off and try again (a maximum of 5 times – if
the flame still fails to ignite, leave at the off position to allow
unburned gas to dissipate).
Pans with flat base are highly recommended. Also, the size of the pans must be in line with the size
of cooktop elements for most efficient usage. Always centre the pans over the burners and on the
trivets. Using small sized pans on the larger burners will cause heat loss and so energy will be
wasted.
After using any burner, please make sure that it is switched off.
Do not let children come too close while the hobs are hot or in operation.
Clean the cooktop with a warm, damp, wet cloth after use, but ensure the hobs are off and not too
hot. If there is excessive spillage, you can clean the hobs with a warm, damp, slightly soapy cloth
(e.g. dishcloth). Do not use abrasive cleaners or metal scrapers to clean glass, as scratches can
occur.
Never fill a pan more than 1/3 full of oil. Always dry food before frying.
Never use gauze, metal pan diffusers or stands over the hobs, as they can cause the burners to
overheat. Do not use trivets not supplied by Everdure for use with this appliance.
Recommended vessel sizes are as follows:
Auxiliary: Ø100mm-Ø220mm.
Semi-rapid: Ø100mm-Ø240mm.
Rapid: Ø100mm-Ø260mm
9

Related product manuals