EasyManua.ls Logo

Everglades 355 CC - Appendix F; Troubleshooting Guide; Control Systems

Everglades 355 CC
148 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
143
TROUBLESHOOTING GUIDE
Appendix F:
PROBLEM CAUSE AND SOLUTION
CONTROL SYSTEMS
Hydraulic Steering is slow to respond & erratic and/or the
steering wheel feels bumpy.
• Steeringsystemislowonuid.Fillandbleedsystem.
• Steering system has air in it. Fill and bleed system.
• A component in the steering system is binding. Check and
adjust or repair binding component.
• Engine steering spindle is binding. Grease spindle.
The boat wanders and will not hold a course at cruise
speeds.
• There could be air in the steering system. Fill & bleed the
system.
• The engines are not aligned properly. Align engines.
• Engine steering spindle is binding. Grease spindle.
Steering is unusually hard.
• The fuse for the power steering circuit has blown. Replace
the fuse.
• An internal fuse in the power steering pump system has
blown. Refer to the steering owners manual for fuse location
and replace the fuse or contact your dealer for assistance.
• A steering line is kinked or collapsed. Replace kinked or
collapsed line.
An engine will not start with the shift control lever in neu-
tral.
• The shift control lever is not in the neutral detent. Try mov-
ing the shift lever slightly.
• There is a loose wire on the neutral safety switch in the
control. Inspect wires and repair loose connections.
• The starter or ignition switch is bad.
• There is a problem with the electronic control system at the
helm control, module or at the engine. Have the system
servicedbyaqualiedmarinetechnician.
PERFORMANCE PROBLEMS
Boat is sluggish and has lost speed & RPM.
• The boat may be need to have marine growth cleaned from
hull and running gear.
• Propellers may be damaged & need repair.
• Weeds or line around the propellers. Clean propellers.
• Boat is overloaded. Reduce load.
• Check for excessive water in the bilge. Pump out bilge &
nd&correcttheproblem.
• One of the throttles is not responding properly and the engine
is not getting full throttle. Have the throttle control system
checkedbyaqualiedmarinetechnician.
The boat vibrates at cruising speeds.
• Propellers may be damaged & need repair.
• A propeller or propeller shaft is bent. Repair or replace
damaged components.
• The running gear is fouled by marine growth or rope. Clean
running gear.
• The engines are not trimmed properly. Trim engines.

Table of Contents

Related product manuals