EasyManua.ls Logo

Everglades 355 CC - Page 99

Everglades 355 CC
148 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
99
Exterior Equipment
A molded recess on each side of the seat base
is designed for re extinguishers. The recessed
mounting location keeps the re extinguishers out
of the way and readily available.
Cooler Compartment
A 94 quart cooler is mounted in a special compart-
ment at the front of the seat base below the helm
seats. The cooler is secured with a door that is
hinged at the bottom and secured with two spring
actuated latches. To slide the cooler out of the
compartment, release the two latches and rotate
the door down until it lays at on the cockpit sole.
Then slide the cooler out. Make sure the cooler
is slid completely into the compartment with the
door closed and secured with both latches before
operating the boat.
Bow Seats and Storage Compartments
There are 3 storage compartments located in the
bow below the seats that drain to the bilge. Each
hatch is equipped with a gas charged spring that
helps raise the hatch and holds it in the open or
closed position.
The side compartment hatches are secured with
draw latches and the center compartment hatch
near the bow is secured with a ush, twist lock
latch that secures the hatch in the closed position.
There is a large red dot in the handle that indicates
that the latch is in the open position and the hatch
is not secure. Always make sure the hatches are
closed with the latches in the secured position be-
fore operating the boat above idle speed.
Helm Seats in Leaning Post Position
Cooler in Cooler Compartment
Forward Bow Storage Compartment
Bow Seats in Casting/Fishing Platform Position

Table of Contents

Related product manuals