2
Installation Steps 25
EVERSYS AG CP89 Rue du Biais 19 CH-1957 Ardon
2 This appliance is electrically safe only when properly earthed as
described in the current electrical safety specifications. Check for
compliance and, when in doubt, have the wiring thoroughly
inspected by skilled personnel. The manufacturer does not take
any responsibility for any damage caused by incorrect earthing.
3 Using adapters, multiple plugs and cable extensions is not rec-
ommended. If they are indispensable, use simple or multiple
adapters and extensions that comply with the current safety reg-
ulations. Do not exceed the limit current load shown on simple
adapters and extensions, and the limit power load shown on
multiple adapters. To prevent dangerous overheating, uncoil the
power cord to its full length. When the appliance is permanently
connected to a field terminal, a disconnection switch must be
installed at the field terminal. The disconnection switch must
disconnect all power lines from the power network, except for
the earthing. The distance between the contacts of the discon-
nection switch must be at least 3.0 mm.
1.4 WATER CONNECTION
The machine requires a cold water connection of 3/8 inch. The dis-
tance between the machine and the water connection should not
be more than 1 meter (to connect the appliance, use the supplied
original hose only). The water pressure must be between 2 and 4 bar
(29...58 psi). If the water pressure is more than 4 bar (58 psi), a pres-
sure reducing valve must be installed.
WARNING
Risk of Fire
Installation of wrong or improper electric plugs can cause short circuit
resulting in fire.
The plug has to be selected and installed by qualified service personnel
only, according to the labels on the power cord.
To Next Page
Loading...
