3
Misc. Codes / Standards
The Installation must conform to local codes or,
in the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.1/NFPA 54 - latest
edition.
The appliance, when installed, must be electri-
cally grounded in accordance with local codes or,
in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 - latest edition.
Check the packaging list to be sure that you have
all the necessary parts in usable condition. Also
check for concealed damage.
Tools and Building Supplies
Normally Required
Tools Should Include:
Building Supplies Should Include:
(noncombustible)
(noncombustible)
(for packing around gas-line penetration holes)
Codes
Adhere to all local codes or in their absence the
latest edition of The National Fuel Gas Code ANSI
Z223.1 or NFPA 54 - latest edition which can be
obtained from The American National Standards
Institute, Inc. (1430 Broadway, New York, NY,
10018) or National Fire Protection Association,
TABLE OF CONTENTS
Important Safety Information ........... Page 2
.................................. Page 3
General Information ......................... Page 3
Burn-in Period .................................. Page 3
Tools/Building Supplies .................... Page 3
Codes ............................................... Page 3
Combustion And Ventilation Air ....... Page 4
Cold Climate Insulation .................... Page 4
Page 5
..........................
Clearances .......................................
Assembly Steps ............................... Page 8
......................... Page 8
...............................
...........................
................................... Page 10
..................... Page 11
.............................. Page 11
Installation .................................. Page 12
............................... Page 15
Accessories/components ................. Page 15
.................... Page 17
This installation manual will help you obtain
your appliance and vent system.
PLEASE READ AND UNDERSTAND
THESE INSTRUCTIONS BEFORE BEGIN-
NING YOUR INSTALLATION.
Packaging List
GENERAL INFORMATION
to accept all ANSI Z21.11.2 approved Decorative
For the
appropriate Vent-Free Gas Log Room Heater
model, refer to Page 16 (see
Vent-Free Gas Log
Sets). Refer to the installation instructions pro-
vided with the log sets for detailed instructions.
This installation manual along with the vent-free
gas log installation manual will enable you to
-
lation of your room heater system.
com ponents under any circumstances. Any
-
cessories, may void the warranty, listings and
approvals of this system and could result in an
unsafe and potentially dangerous installation.
-
sures for Gas-Fired Unvented Decorative Room
Burn-in Period
appliance there will be some odor due to the
curing of the paint and burning off of lubricants
-
mend that you open windows and ventilate the
house during the initial burns. The paint emits
Depending on your use, the burn-in period may
take a few hours or a few days.
KEEP YOUR HOUSE WELL VENTILATED
DURING THE BURN-IN PERIOD. THE ODOR
AND HAZE EMITTED DURING THE BURN-IN
PERIOD CAN BE QUITE NOTICEABLE AND MAY
SETOFFASMOKEDETECTOR.
If an optional blower is installed, Do not turn it
on during the Burn-In period.
CONGRATULATIONS!
In selecting this Everwarm
Everwarm
Please read and carefully follow all of the instructions found in this manual. Please pay
Everwarm product.
To Next Page
Loading...