R410A 60Hz EER 2.36 Series Service Manual
1. Remote Controller
Instructions of remote controller
“HVAC No.2” remote controller (compatibility with wire controller or lamp board): extension code, applicable
to most VRV models.
“HVAC No.3” remote controller (compatibility with wire controller or lamp board): general code, applicable to
all models (except of Window machine).
Do not place remote controller near heat sources such as electric blankets or heating furances.
Do not place remote controller in direct sunlight.
Be careful not to drop, otherwise it may cause damage.
No obstacle between the signal receiver and the remote controller, so as not to affect the
transmission and reception of the signal.
Do not splash water or other liquids onto the remote controller.
Open the external pendulum wind.
Left and right swinging
Open the internal pendulum wind.
Point the remote controller to the air conditioner, press the button on the remote controller, and
send the command signal to the air conditioner.
If the signal is received correctly, the air conditioner will issue a "beep" prompt.
If the remote controller is not available, please replace the new battery and try again. But if the
problem persists, please contact the seller or our authorized service center.
Open or close the air-conditioner.
Reduce fan speed in one gear.
Minimum wind speed will swich to
the automatic wind, and swich to the
highest wind when pressing again.
Timer
Setting timing ON/OFF.
Modify the current time of the remote
controller.
Lock the remote controller bottons.
Decrease the setting temperature.
Increase the setting temperature.
Select modes, including automatic,
cooling, dehumidification, fan and
heating mode.
Increase fan speed in one gear.
Highest wind speed will swich to the
automatic wind, and swich to the
minimum wind when pressing again.
Enter the turbo function. Decide
whether to have this function
according to the actual model.
Automatically setting 26 in
cooling or heating mode.
Enter the sleep function. Decide
whether to have this function
according to the actual model.
Forced closing or lighting of display
panel. Decide whether to have this
function according to the actual
model.
Open the external pendulum wind.
Left and right swinging
Open the internal pendulum wind.
To Next Page