38
ENGINE OPERATION
6
■
Forward
Quickly push the control lever to the
Forward (F) position 32˚, where the
gear is connected, while lifting up on
the lock button located at the bottom
of the control lever grip. Further
shifting will open the throttle.
■
Reverse
Quickly pull the control lever to the
Reverse (R) position at 32˚, where the
gear is connected, while lifting up on
the lock button located at the bottom
of the control lever grip. Further
shifting will open the throttle.
Note
The control lever is inoperative unless
the free accel lever is in the fully
closed position.
Note
Reduce the engine speed when
the control lever is in Neutral and
do not increase the engine speed
unnecessarily.
R, TE and TP type
①
Turn the throttle grip to the slow
position.
②
Put the shift lever in the Neutral po-
sition.
Run the engine for 2-3 minutes at
idling speed if it has been running
at full speed.
③
Push the stop switch to stop the
engine or release the stop switch
lock.
6. Stopping
Stop switch Stop Switch Lock
!
●
Do not shift into Reverse during
planing, or control will be lost leading
to serious personal injury, boat
may swamp, and/or hull may be
damaged.
●
Do not shift into Reverse during
cruising, or control may be lost,
falling down or causing passenger(s)
to be thrown overboard. Leading to
serious personal injury, and steering
system and/or shifting mechanism
may be damaged.
OM_E_10HP_body_111213.indd 38 11/12/13 13:23
To Next Page
Loading...
