Evinrude E15D User Manual

26
Using Your Evinrude E-TEC Outboard
Move the shift lever to NEUTRAL. Refer to
Shifting and Speed Control - Tiller Models
on page 28.
Twist throttle grip to SLOWEST speed posi-
tion.
DO NOT advance the throttle before start-up.
Advancing the throttle overrides the electronic
idle control system.
If the outboard is started with the throttle ad-
vanced, the outboard will be in a safety mode.
It will not respond to throttle until the throttle
twist grip is returned to slowest speed posi-
tion.
After the engine starts, the engine manage-
ment module (EMM) automatically increases
idle speed slightly. Idle speed will decrease as
the engine warms up.
Starting – Tiller Rope Models
While seated, grasp the starter handle and
pull slowly until the starter engages, then pull
hard. Repeat, if needed, until outboard starts.
To prevent damage to starter
assembly, allow starter cord to rewind
before releasing starter handle.
IMPORTANT: Engine will not start if outboard
is in gear or if tether cord is not in place.
If your outboard does not react normally to
this starting procedure or if it fails to start, re-
fer to Troubleshooting on page 62.
Starting – Tiller Electric Models
While seated, press the start button. (If
equipped with a key switch, it must be in the
1. NEUTRAL
007006
A WARNING
Always shift to NEUTRAL before starting
the outboard to prevent sudden boat
movement, which can cause injury.
1. SLOWEST speed position
007067
1
1
1
1. Starter handle
2. NEUTRAL
007009
NOTICE
1

Evinrude E15D Specifications

General

Brand	Evinrude
Model	E15D
Category	Outboard Motor
Language	English