27
OPERATION
ON position.) Crank the engine no longer than
20 seconds.
Upon start-up, release the button.
If the engine did not start, release the button
momentarily, then try again.
The starter motor can be dam-
aged if operated continuously for more
than 20 seconds.
IMPORTANT: Engine will not start if outboard
is in gear or if tether cord is not in place.
If your outboard does not react normally to
this starting procedure or if it fails to start, re-
fer to Troubleshooting on page 62.
After Engine Starts
Check the water pump indicator. A steady
stream of water indicates the water pump is
working. If a steady stream of water from the
water pump indicator is not visible, stop the
engine. Refer to Engine Overheating on
page 43.
Engine Stopping
Twist the throttle grip to SLOWEST speed po-
sition.
Move shift lever to NEUTRAL.
Press the engine cut–off switch until the out-
board stops running. If equipped, close the
vent screw on the fuel tank’s filler cap.
Disconnecting the Fuel Hose
Disconnect the fuel hose from the fuel con-
nector.
If equipped, close vent screw on fuel tank cap.
1. Start button
007010
1. Water pump indicator
007011
1. STOP button
007012 HK
A WARNING
A small amount of fuel may be released
when the fuel connector is disconnected.
Always wipe off any fuel spillage.
1. Fuel connector
007004
To Next Page
Loading...
Need help?
General
