Evinrude E4RL4 - Engine Oil and Gear Oil Service

40
INSPECTION AND MAINTENANCE
10
Maintaining engine oil
If the engine oil is low, the life of the
engine will be shortened significantly.
■
Checking oil level
①
Stop the engine and set it in a
vertical position.
②
Remove the top cowl.
③
Remove the oil filter cap.
④
Wipe oil on the oil dipstick with a
clean rag.
⑤
Screw in the dipstick into the oil
filter mouth (screw in completely).
⑥
Take out the dipstick and check
the oil level.
⑦
Reset the dipstick in to the oil filter
mouth.
■
Replenishing engine oil
If the oil level is low, or at lowest mark,
add recommended oil to the upper
dipstick mark.
Notes
Consult with an authorized dealer
if the engine oil is milky color, or
appears contaminated.
Oil Filler Cap
(Dipstick)
Lower Level 350 mL
Upper Level 450 mL
●
Do not add engine oil of brand and
grade other than existing one. In
case engine oil of other brand or
grade is added, drain all oil and ask
dealer for treatment.
●
In case other than engine oil such
as gasoline is put in the oil chamber,
empty the chamber and ask dealer
for treatment.
●
When replenishing engine oil, be
careful not to allow entry of foreign
matters such as dust and water into
oil chamber.
●
Wipe off engine oil well immediately
if spilled.
●
Do not replenish engine oil over
upper limit. If overfilled, remove oil
to upper limit. If engine oil is over
the upper limit, it can leak potentially
leading to engine damage.
!
CAUTION
Notes
The oil level should be checked when
the engine is cold.
下限350ml
上限450ml
OM_E_4HP_body_111213.indd 40 11/12/13 13:21