14 - General Information
ENGINE SPECIFICATIONS
115 Models
Displacement 105.4 cu. in. (1726 cc)
Engine Type 60° V, 4 Cylinder, Two-Cycle,
Direct Injection
Full Throttle Operating Range 115 - 5250 to 5750 RPM
Power
(1)
115 - 115 HP (85.8 kw) @ 5500 RPM
Idle RPM in Gear
(2)
650 ± 50
Ignition Timing
(2)
Not Adjustable
Emission Control System:
per SAE J1930
(2)
ECM, DFI (Engine Control Module, Direct Fuel Injection)
Fuel Requirements
(2)
87 Pump Posted AKI (90 RON) - Refer to Fuel and Oil
Oil
Evinrude
direct injection oil - Refer to Fuel and Oil
Warning Signals Controlled by the engine’s
EMM
Battery, Minimum 500 CCA (620 MCA) 12 volt
Spark Plug
(2)(3)
Torque
Refer to ECI Label
15-22 ft. lbs. (20-30 N·m)
Start Assist Circuit Fuse
Evinrude
P/N 514768
Fuses Refer to Power Distribution Panel
Fuel Filter
Evinrude
P/N 502906
Alternator 35-Amp, Fully Regulated
Gearcase - Lubricant
Capacity
Evinrude Ultra-HPF™
gearcase lubricant
L Models - 26 fl. oz. (770 ml)
X Models - 42 fl. oz. (1250 ml)
Pwr. Trim/Tilt - Fluid Capacity 21 fl. oz. (622 ml)
Propeller
(4)
Refer to Propeller Selection
Weight
(7)
L Models - 365 lbs. (166 kg)
X Models - 390 lbs. (177 kg)
Sound at Driver’s Ear
(LpA) ICOMIA 39.94
80.8 dB(A)
Transom Height L Models - 19 1/2 to 20 in. (495 to 508 mm)
X Models - 24 1/2 to 25 in. (622 to 635 mm)
To Next Page
Loading...
