Maintenance - 51
Electrical and ignition wires and connections,
inspect
DD
Gearcase lubricant replace 5 D D
Powerhead synchronization and linkage, inspect
(2)
7D D
Access EMM information, resolve any service
codes
DD
Fuel filter and oil filter(s) inspection, eliminate
contamination
D
Gearcase lubricant, inspect fill level and condition
of lube
5D
Fuel and oil filter(s) replace D
Propeller shaft splines, inspect and lubricate 7 D
Starter pinion shaft, inspect and lubricate 115-175
models
(2)
9D
Exhaust back- pressure nipple, decarbonize
(2)
D
Spark plugs, replace
(2)
D
Driveshaft splines, inspect and lubricate 8 D
Water pump, inspect and replace D
(1) Also recommended at 10-Hour Inspection
(2) Emission-related component
D
Dealer Performed Service
O
Operator Performed Service
4
Evinrude
anti-corrosion spray or
Evinrude
“6 in 1” multi-purpose lubricant
5
Ultra-HPF
gearcase lubricant
6 Power Trim/Tilt Fluid
7
Triple-Guard
grease
8
Evinrude Moly Lube
P/N 175356
9 Starter Bendix Lube Only P/N 337016
Engine Maintenance and Inspection Schedule
Description
Engine
Care
Product
Frequency
Each Use
10-Hour
Inspection
Every 50 Hours
or 6 months
Every 100 Hours
or Annually
Every 200 Hours
or Biannually
To Next Page
Loading...
