12
¾
Trip Log Reset
The trip log is the cumulative total number of gallons (or liters) of fuel used
during each boat outing. Fuel usage can be reset to zero by resetting the trip
log. The trip log (fuel usage total) can be viewed on the Fuel Used screen of
the optional
I-Command
speedometer gauge (See “Fuel Used” on page 24).
Re-setting trip log — From the System Set-Up screen, scroll to the Trip
Log Reset display. Press ENTER to reset the trip log. This resets the Fuel
Used screen of the speedometer (see “Fuel Used” on page 24).
¾
Engine Data Display (ON/OFF)
LCD screens can be turned ON or OFF to “skip” screens that do not display
data or are not applicable. When a screen is turned off, the LCD screen will
not appear on the engine data menu. (For a list of the available Engine Data
screens, see “Engine Data” on page 13.)
Turning a screen ON / OFF — From the System Set-up screen, select the
Set-up Engine Data screen by pressing ENTER.
Scroll through the Engine Data screens by pressing UP / DOWN buttons. If
the data display is turned on, “ON” appears in the upper right corner. When
the desired Engine Data screen appears, press ENTER. “SET” appears in
the upper right corner. Using the UP / DOWN button, select ON or OFF.
Press ENTER to set the display.
Tachometer User Preferences
¾
Instrument Backlighting
Each
I-Command
instrument gauge face is red backlighted for increased
low-light visibility. The brightness of the lighting can be adjusted to user pref-
erence. Setting the tachometer backlighting will adjust all other gauges on
the
I-Command
system. If another tachometer is present, it can be adjusted
independently.
Turning backlighting ON / OFF — Press and buttons simultaneously.
Adjusting backlighting — With backlighting on, press UP or DOWN button
to adjust the brightness. Once desired brightness is selected, press UP and
DOWN buttons simultaneously again to set the adjustment.
To Next Page
Loading...
Need help?
General