Evo Affinity 30G - LP Gas Leak Checking; Testing LP Connections for Leaks

To Next Page

To Previous Page

INSTALLATION INSTRUCTIONS

Affinity 30G

Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA

Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com

CHECKING GAS LEAKS (LP)

Do not ignite burners or use an open ﬂ ame to check for gas leaks. Be sure there are no sparks

or open ﬂ ames in the area while you check for gas leaks. Flames and sparks will result in a ﬁ re

or explosion which can cause serious bodily injury or death and damage to property.

DANGER

Note: All factory-made connections have been thoughly checked for gas leaks. The

burners and ignition system has been ﬂ ame tested. As a safety precaution, we

recommend you recheck all ﬁ ttings for leaks before using your Evo grill. Shipping and

handling may loosen or damage a gas ﬁ tting.

To perform a leak check you will need a solution of soap and water and a brush or rag to

wet all gas connections.

1. Turn all control knobs to the OFF position.

2. Turn on gas supply and check for leaks by wetting the connections with the soap and water

solution and watching for bubbles. If bubbles appear, or if a bubble grows, there is a leak.

Note: Since some leak test solutions, including soap and water, may be slightly

corrosive, all connections should be rinsed with water after checking for leaks.

WARNING

Perform leak checks even if your grill was

dealer or store assembled.

You should check for gas leaks every time

you disconnect and reconnect a gas ﬁ tting.

WARNING

CHECK ALL GAS CONNECTIONS:

1. Hose to Regulator.

2. Regulator to Gas Supply connection.

Other manuals for Evo Affinity 30G