evoheat 270 - Warranty

EVO 270 HEAT PUMP WARRANTY
1. The tank is guaranteed for a period of five (5) years from the date of purchase when
installed in a domestic premises and in accordance with the instruction manual.
2. The compressor is guaranteed for two (2) years from the date of purchase.
3. All other parts are guaranteed for two (2) years from the date of purchase
4. This warranty covers all labour for twelve (12) months from the date of purchase
5. This warranty excludes any defect or injury caused by or resulting from misuse, abuse,
neglect, accidental damage, improper voltage, vermin infestation, incompetent installation, any
fault not attributable to faulty manufacture or parts, any modifications which affect the reliability
or performance of the unit.
6. This warranty does not cover the following:
a. Natural Disasters (hail, lightning, flood, fire etc.)
b. Rust or damage to paintwork
c. When serviced by an unauthorized person without the permission of Evo Industries
Australia
d. When a unit is installed by an unqualified person
e. Where a unit is incorrectly installed
f. When failure occurs due to improper or faulty installation
g. Failure due to improper maintenance (refer Operating Instructions)
h. No Fault Found' service calls where the perceived problem is explained within the
Operation Instructions
I. Costs associated with delivery, handling, freighting, or damage to the product in transit.
7. If warranty service is required you should:
a. contact Evo Industries Australia on 1300 85 99 33 or via our Contact Us page on our web
site at www.evoheat.com.au
b. provide a copy of your receipt as proof of purchase
c. have completed the online warranty registration or provide a completed warranty card.
8. Home service is available within the normal operating area of your Evo Industries
authorized Service Centre. Service outside this area will incur a travelling fee.
Unless otherwise specified to the purchaser, the benefits conferred by this express warranty and
additional to all other conditions, warranties, rights and remedies expressed or implied by the Trade
Practices Act 1974 and similar consumer protection provisions contained in legislation of the States
and Territories and all other obligations and liabilities on the part of the manufacturer or supplier and
nothing contained herein shall restrict or modify such rights, remedies, obligations or liabilities.
33
7.Appendix
7.7.Overheating protector
Picture 11
The overheating protector is used to turn the power off, preventing the hot water from being
heated too high. To return the unit to its normal operational status it will have to be re set manually.
Please contact Evoheat for service if this occurs.
Operation details
To access the overheat protector the front dark grey controller panel must be removed. Remove the
3 screws on the front panel and push the front cover upwards.
Then remove the screws covering the overheat protector panel as below..
Remove the screws and open the cover
Press the red button to reset
7.8 Draining the tank
1. Close the cold water inlet valve into the Evoheat 270.
2. Open a hot water tap inside the premises.
3. Undo the drain plug on the base of the unit to drain the water from the system.
CAUTION. THE WATER FROM THE HOT WATER TAP AND THE DRAIN PLUG WILL BE
HOT. BE CAREFUL OF BURNS AND SCALDS.WEAR PROTECTIVE CLOTHING