14
AAddjjuussttmmeenntt ooff tthhee tthhiicckknneessss
The Pebble and Dualys printers are equipped with a manual system for setting the thickness of the
cards, which is accessible either through the feeder frame, or through the inside of the printing
modul
e when the cover is open.
The Pebble and Dualys printers accept card thickness between 0.25 mm (10 mil) and 1 mm
(40 mil). The factory thickness setting of the cards is 0.76 mm (30 mil).
To adjust the thickness of the cards using the feeder cage:
To adjust the thickness of the cards from the inside the printer:
1. Remove the feeder
from the printer as
shown.
2. Adjust the thickness of the
cards used by moving the
handle from right to left on
the required card thickness.
2. If applic
abl
e, r
emove the ribbon
from the printer. Then adjust the
thickness of the cards used by
moving the handle from right to
l
eft on the r
equir
ed c
ar
d thicknes
s.
3. Reins
t
all the ribbon
in the printer and
close the cover.
1. Open the c
o
v
er of the
printer by pressing the
opening lever and then
turn it.
3. Put the feeder back in
the printer. Then press
on the top of the feeder
until it clicks.
To Next Page
Loading...
