36
8. Close the cover. The new print head is now installed.
Step 3 - Setting the parameters of the new print head
1. Power up the printer and make sure it is properly connected to a computer
on which the Pebble (or Dualys) printer print driver is installed.
2. Under print driver “Properties”, click on the “Tools” dialogue box.
3. In the “Dialog with printer” portion, enter the following command: Pkn;x
X = the print head kit number that you read in Step 2
Example: if the print head kit number is: 179-004-00048, you must enter the command:
Pkn;179-004-00048
If the print head kit number is not entered correctly, printer malfunctions can occur and the
warranty may be canceled.
Step 4 - Cleaning the printer
On the LED control panel, the cleaning light comes on as follows:
Cl
eaning is absolutely required after a print head change.
No printing should be started before this operation has been completed.
Refer to the
Clean Card Feed Module chapter to perform this operation.
Also service the cleaning roller and replace cards and ribbons.
Onc
e the cl
eaning is done, y
our Ev
olis printer is again ready to personalize your cards.
UUppddaattee tthhee FFiirrmmwwaarree
5. Insert the
head vertically
into the two
guides so as
to lock the
f
ork lugs into
their seats.
6. T
urn the print
head by
pressing the
t
op of the metal
piece in order
t
o clip it into
the spring-
mount
ed part.
To Next Page
Loading...
