20
INSTALLATION
• Power Supply
Connect the power cable to the ‘ADAPTER INPUT’ placed on the lower back panel of the device.
Connect the cable. Turn on the power switch placed next to Power input, then after moment initial
screen animation is displayed automatically.
Caution
1. Before connecting a peripheral device to the device, the power should be turned off. Otherwise the
devices can be damaged by electric shock or malfunction.
2. When the device and the peripheral devices are connected each other, the order of turning of the
devices should start from the device to keep the functions and safe of the device.
3. This device should be only powered through the cable provided by OUR OMPANY.
4. Be careful not to touch the base part of the scale when switching on the device. If at turning on the switch
loads any weight on plate electrode, a measuring error might occur with the scale’s zero point.
5. Do not install the equipment where power can not be disconnected.
2) Connecting Printer
① Connecting the device and the printer directly
Connect A4 printer offered with this device to the “USB(A)” port placed on the rear panel of this
device with USB cable.
To Next Page
Loading...
Need help?
General