• In order to keep one’s health and the balance of body composition, check the changes of body composition through continuous analysis
and compare the results. Make sure that the body composition should are measured under the same physical and environmental
conditions. If the condition before the measurement such as volume of a meal, meal time, and activities (exercise, sauna, drinking lots of
beverage, urination, etc.) are kept same, the reproducibility of a device is obtained. Therefore, the data can be used to evaluate the change
of body composition.
2. Correct position to measure
1) How to touch electrodes
• Make sure that the plate electrodes are clean.
• Take off the socks or stockings then, stand on the plate electrodes.
• Remove sweat or foreign matters on the soles.
• Fairly place the bare feet on the plate electrodes. Make sure that the clothes are not between the soles and the plate electrodes.
• When ankle electrode is selected to measure body composition, pull down the socks as show in the picture
22
MEASUREMENT ANALYSIS
To Next Page
Loading...
Need help?
General