STORAGE & MAINTENANCE
1. Pay attention to the allowable value to electric current
2. Avoid direct sunlight, humidity, dust, thick oil and salty or extreme changes in temperature.
3. Do not install or store the device in a place where any chemicals or gas is stored.
4. Do not use the device in any unstable, vibrating, or impact-giving area.
5. Do not put or drop anything on the device and avoid strong impact.
6. Do not disassemble or remodel the device.
7. Do not splash any fluid on this device or insert any foreign substances.
8. If this unit has not been used for a long time, use this after confirming by an expert if all function and appearance are in good condition.
9. In case of inserting foreign substances or exposing to particular environment, this device must be examined by an expert before use.
10. Use the power cable, plug, and fuse that are offered by our company. At this time, confirm the covering of cable, the state of plug connection, and other check points to the
things below.
• RS 232C cable
• USB port
• Adapter
11. When pulling out the power cable, turn off the power switch first and then pull the plug out.
12. Storage ambient: Temperature -25 ~ 70 °C, Humidity lower than 93 % (non condensing)
13. Operation ambient: Temperature 5 ~ 40 °C, Humidity 15 ~ 93 % (non condensing)
14. Do not store or use this device under 70 kPa (700 mbar) or over 106 kPa (1060 mbar)of atmospheric pressure.
15. Cleaning & Disinfection
① Cleaning: Use a soft gauze cloth with volatile liquid like alcohol (Ethyl or Isopropyl alcohol 70~90%) to clean it.
Clean it every 2~3days. Do not use a wet cloth.
② Disinfection: After measurement, use a soft gauze cloth with volatile liquid like benzene and alcohol. Then, wipe the enclosure with soft lint. Please wipe after
every measurement for electrode disinfection.
16. Refer to “SAFETY PRECAUTIONS.”
28
To Next Page
Loading...
Need help?
General