number [1~8], and then press [#] to confirm. The main unit emits a long
beep and you will hear “remote control coding”. The [ ] indicator is
on without flashing; press any button on the wireless remote controller,
the main unit makes a long beep and you will hear “coding completed”,
[ ] indicator goes out, indicating the remote controller succeeds in
coding.
Operating method: [20] [A] [#]
A indicates：1~8 remote controllers number. You can add maximum 8
remote controllers.
LCD display:
Delete Remote Controller
The remote controller can’t control the main unit after it’s deleted.
In setup state, use keypad to input [21], then input the remote controller
number [1-8], and then press [#] to confirm. The main unit emits a long
beep and the [Signal] indicator flickers once. You will hear a voice
prompt “delete completed”.
Operating method: [21] [A] [#]
A indicates：1~8 remote controllers number.
Coding of Defense Zone
Wireless detectors have to be coded to the main unit in order to trigger it
alarm.
In setup state, use keypad to input [23], input the defense zone number
you want to code [01~99], and then input [#] to confirm. The main unit
emits a long beep and the corresponding defense zone is displayed on the
screen. You will hear a voice prompt “detector coding”. Then trigger a
wireless detector to emit a wireless signal; after receiving the signal, the
main unit makes a long beep, and you will hear “coding completed”, the
[ ] indicator goes out at the same time.
Operating method: [23] [XX] [#]
XX indicates: 01 ~99 defense zones number
LCD display:
To Next Page
Loading...