Evolu7 GSM - Delete Defense Zone; Change Password; Operation Password; Program Password

54
 Delete Defense Zone
The wireless detector can’t control the main unit after it’s deleted.
In setup state, use keypad to input [24], then input the defense zone
number you want to delete [01~99], and then input [#] to confirm. The
main unit emits a long beep and the defense zone indicator flickers once.
You will hear a voice prompt “delete completed”.
Operating method: [24]  [XX]  [#]
XX indicates: 01 ~99 defense zones number
 Change Password
1 Change Operation Password
Operation password is the password used to disarm or remote control.
In setup status, use keypad to input [30], then input the 4-digit new
password, and then press [#] to confirm. The main unit will make a long
beep and you will hear a voice prompt “setting completed”.
Operating method: [30]  [XXXX]  [#]
XXXX indicates: the new 4-digit password
For example: change the system password to 1012
Operating method: [30]  [1012]  [#]
LCD display:
2 Change Program Password
Program password is the password you should input in order to setup
the system.
In setup status, use keypad to input [31], then input the 4-digit new
password, and then press [#] to confirm. The main unit will make a long
beep and you will hear a voice prompt “setting completed”.
Operating method: [31]  [XXXX]  [#]
XXXX indicates: the new 4-digit password
For example: change the system password to 2846
Operating method: [31]  [2846]  [#]
LCD display: