Operation Instructions
System status.
There are 4 status as following:
Arm: defense zone 1~99 will alarm when detectors are triggered
Home Arm: in arm status, the defense zone which is set as [Home
Arm] will alarm when detectors are triggered.
Disarm: defense zone 1~99 will not alarm when detector triggered
(except 24 hours defense zone)
System setup status: In this status, all defense zones will not alarm
when detectors are triggered.
Remote Controller Operation
Users can use remote controller to set system as Out Arm, Home Arm,
Emergency Alarm, Real-time Disarm and etc.
Out Arm: Press button
Disarm: Press button
Home Arm: Press button
Emergency Alarm: Press button, system will alarm at once.
Out Arm
It means to guard all around your house while everyone is going out; all
the detectors of the host are always working; when the detector is
triggered by detecting source (anti-theft, fire prevention, gas leak, etc.),
the alarm system will sound the alarm.
Press [Out Home ] button on keypad, system will make a beep per
second and totally 100 beeps. The [OUT ARM] indicator will be on
without flashing. It means Out Arm is set successfully.
Arm Operation: Press [Out Home ] button, the system will enter arm
status 100 seconds later.
LCD display:
To Next Page
Loading...