batteries, deform or even melt some plastic parts.
Do not place the system in excessively cold locations. Otherwise
condensation many occur and damage the circuit board of the alarm
system.
It is recommended that you check and test the alarm system
periodically:
Check the main unit every three months:
1. Whether it can arm/disarm normally;
2. Whether it can dial the number for alarm normally;
3. Whether it can receive wireless detectors’ signal normally;
4. Whether the back-up battery can work normally.
Check the wireless detectors once a month:
1. Trigger wireless detectors to see if system can alarm normally;
2. Check all detectors’ batteries to see if it’s in low voltage;
3. Check whether wireless detectors can send signal to the main unit
normally.
Check the SIM card:
1. Check the use of SIM card, such as network signal, balance, etc.
2. Make sure the PIN code verification of the SIM card is closed.
3. Please keep the password and SIM card number safe, in case that
other people remote control the system illegally.
Since the alarm system is continuously in operation or standby
mode, the supply adaptor of the control panel shall be connected to a safe
and reliable socket.
Do not place the system near your bedroom or office table,
because the siren will make high-loudness sound in the case of alarm,
To Next Page
Loading...