Evolution R230 DCT - THE ON;OFF TRIGGER SWITCH; CUTTING ADVICE; PRE-CUTTING CHECKS

19
www.evolutionpowertools.com
EN
FIG. 15
THE ON/OFF TRIGGER SWITCH (Fig. 15)
(All Evolution machines)
Note: These machines are fitted with a Safety Start Trigger
Switch.
To start the machine:
• Push in the safety lock button on the side of the handle
with your thumb.
• Depress the main trigger switch to start the motor.
WARNING: Never start the saw with the cutting edge of
the cutting blade in contact with the workpiece surface.
CUTTING ADVICE
Note: As Evolution Power Tools has no control of how
its equipment may be used, the following guidelines
(not exhaustive) are offered to help operators use the
equipment safely and efficiently.
PRE-CUTTING CHECKS
• Ensure that the power supply matches the requirements
specified on the machines rating plate.
• Ensure that the machines trigger switch is in the
‘OFF’ position. If the machine were to be connected
to a power source with the trigger switch in the ‘ON’
position, the machine could start operating immediately
with the possibility of a serious accident occurring.
• If an extension cable is required it must be of a suitable
type for the work environment. If used outdoors it
should be waterproof and so labelled.
• The manufacturers instructions should be followed
when using an extension cable.
• Route any extension cable so that it does not pose a trip
(or any other) hazard to the operator, colleagues or any
bystanders