Need help?Do you have a question about the Evolution R255 MTS and is the answer not in the manual?
General| Blade Diameter | 255 mm |
|---|---|
| Bore | 25.4 mm |
| Max. Cut Depth (0° x 0°) | 90 mm |
| Max. Cut Depth (45° x 45°) | 45 mm |
| Saw Type | Mitre Saw |
| Max Cutting Depth at 90° | 90 mm |
| Max. Cut Depth (45° x 0°) | 45 mm |
| No Load Speed | 2500 rpm |
| Motor Power | 1600 W |
| No-Load Speed | 2500 rpm |
| Max Cutting Depth at 45° | 45 mm |
Safety measures for the machine's electrical components and usage.
Guidelines for operating the tool in outdoor environments.
Comprehensive safety instructions covering work area, electrical, personal, and tool care.
Safety instructions concerning the proper use and maintenance of machine guards.
Safety guidelines and precautions for various cutting operations.
Explains kickback and provides warnings to prevent it.
Instructions for safely unpacking the machine and checking its contents.
Steps for assembling the main stand components of the machine.
Instructions for attaching the side table extension panels.
Details on assembling and positioning the fence rail.
Procedures for checking and adjusting the rip fence for parallelism.
Instructions for fitting and using the sliding mitre gauge.
How to safely turn the machine on and off using the switch.
Procedure for adjusting the blade height.
How to tilt the saw blade up to 45 degrees for bevel cuts.
Instructions for positioning and locking the rip fence.
Explanation of the dual scale for setting rip fence distance.
How to fit and use the mitre gauge.
How to fit and adjust the anti-bounce device.
Procedure for making straight cross-cuts on the table saw.
How to perform cross-cuts at an angle using the mitre gauge.
Performing cuts that combine mitre and bevel angles.
Cutting multiple pieces to the same length efficiently.
Instructions for cutting material along its length.
Performing rip cuts with the blade tilted at an angle.
Step-by-step guide for replacing the saw blade.
How to clean the machine after each use.
Information about the riving knife's function and maintenance.
Procedure for adjusting the riving knife's position relative to the blade.
Information on the push stick and its storage.
To Next Page