(8.3)
BODY AND HAND POSITIONING
(Fig. 11)
• Never place your hands within the ‘no hands
zone’ (at least 150mm away from the blade).
Keep hands away from the path of the blade.
• Secure the workpiece firmly to the table and
against the fence to prevent any movement.
• Use a Hold Down Clamp if possible but
check that it is so positioned that it does not
interfere with the path of the blade or other
moving machine parts.
• Avoid awkward operations and hand positions
where a sudden slip could cause your fingers
or a hand to move into the blade.
• Before attempting a cut, make a ‘dry run’
with the power off so that you can see the
path of the blade.
• Keep your hands in position until the
ON/OFF trigger switch has been released
and the blade has completely stopped.
(8.4)
ADJUSTMENT OF
PRECISION ANGLES
Several checks/adjustments are possible on this
machine. The operator will require a 90
0
45
0
/45
0
Set Square (not supplied) to carry out these
checks and adjustments.
WARNING: Checks/adjustments must only
be conducted with the machine disconnected
from the power supply.
Fig. 11
No-Hands Zone
Danger Zone
22
www.evolutionpowertools.com
To Next Page
Loading...
Need help?
General