Cleaning Fuel Strainer
Adding Fuel
NOTICE
Cleaning Fuel Strainer
The fuel strainer helps prevent residue from entering the
To avoid damage to engine, never use stale or
contaminated petrol. Avoid getting dirt or water in fuel tank
Use fresh petrol with a pump octane rating of 87 or higher.
1. Stop the generator if the engine is running. Allow to
completely cool.
2.
3. Remove the fuel cap.
in Table 3.
To clean fuel strainer, you will need:
Household soap and water
Clean, dry cloth
To clean fuel strainer:
1. Stop the generator if the engine is running. Allow to
completely cool.
FIGURE 29: Adding Fuel (EVO2000i+ model illustrated)
2.
3. Remove the fuel cap (A) and fuel strainer (B).
A
B
4. Slowly pour petrol into the fuel tank. Be careful not
to
FIGURE 30: Fuel Level
5. Reinstall the fuel cap and fully tighten.
FIGURE 31: Fuel Strainer Removal
4. Clean the fuel strainer with soap and water.
5. Wipe the fuel strainer clean with a clean, dry cloth.
6. Gently reinstall the fuel strainer and replace the fuel
cap.
NOTE:
Occasional, light spark knock, "pinging", or rattling noise
is normal while operating under heavy loads. If spark
knock, pinging, or rattling occurs at a steady engine
speed, under normal load, drain the fuel (page 26) and
authorized generator dealer.
NOTICE
Running the engine with persistent spark knock or pinging
can cause engine damage. Warranty does not cover parts
damaged by misuse.
EVO1000Si / EVO2000Si / EVO2000SEi / EVO3000Si / EVO3000SEi Inverter Generator Owner’s Manual www.evopower.co.uk 21
To Next Page
Loading...