Transporting Generator
Transporting Generator
WARNING
Hot engine or exhaust system can cause serious
transporting or storing.
Do not leave generator
inside vehicle during high temperatures. This could
cause the fuel to vapourise and possibly explode.
Do not drive across rough terrain while
transporting the generator as this may cause fuel
leakage. Drain fuel from generator.
Do not operate generator while it is in a vehicle.
When transporting the generator:
1. Press the engine control switch to the OFF position.
2. Turn the fuel valve to the OFF position.
3. Turn the fuel cap vent to the OFF position (EVO1000i
model only).
4. Keep the generator level to prevent fuel spillage.
NOTICE
To avoid damage to the generator, take care not to drop or
strike the generator when transporting. Do not place heavy
objects on the generator.
To prepare the generator for long-term storage:.
DANGER
Fuel and its vapors are extremely ble and
explosive under certain conditions.
• NEVER smoke or allow or sparks near
generator or where petrol is stored.
1.
Drain the fuel into a suitable container (see page 26).
2. Change the engine oil (see page 19).
3. Remove the spark plug. Add a tablespoon of clean
engine oil into spark plug hole.
4. Place a rag over the spark plug hole and pull the
recoil starter handle slowly to turn engine and
distribute the oil. Reinstall the spark plug.
At this point, the piston is coming up on its
compression stroke and both intake and exhaust
valves are closed. Storing engine in this position will
help to protect it from internal corrosion.
Draining Fuel
1. Turn the fuel valve to the OFF position.
OFF
Storing Generator
FUE L
ON
OFF
NOTICE
Follow service procedures for preparing generator for
storage. Inadequate or improper care of generator can
result in damage to generator components and will void
limited warranty.
Before storing the generator for extended period of time:
•
Be sure storage area is free of excessive humidity
and dust.
•
Refer to Table 8 for recommended preparation
procedures.
Storage Time
Recommended Preparation
Less than 1
month
No preparation required
1 to 2 months
Fill fuel tank with fresh petrol and add
fuel additive*
More than 2
months
See procedure below
TABLE 8. Recommended Service Procedures Based on
Storage Time
FIGURE 43: Fuel Valve — OFF position
2. Run the engine until it stops due to lack of fuel.
3. Place a suitable container adjacent to the generator.
4. Remove the fuel cap and drain all the fuel into a
container.
FIGURE 44: Draining Fuel
5. When ready to put the generator back into operation,
see page 22).
EVO1000Si / EVO2000Si / EVO2000SEi / EVO3000Si / EVO3000SEi Inverter Generator Owner’s Manual www.evopower.co.uk 25
To Next Page
Loading...