NOTICE
It is very important to maintain the proper level of engine oil
to keep the engine in good running condition.
• Check engine oil level prior to each use.
IMPORTANT! BEFORE STARTING GENERATOR, FILL
WITH ENGINE OIL.
Starting generator with appliances connected can cause
permanent damage to appliances.
• NEVER start generator with electrical appliances
plugged in and turned on.
• Do not move the generator while it is running.
Starting Generator
Starting Generator
WARNING
Before starting generator, be sure to thoroughly
4. Move the choke to the START position.
NOTE:
Place the choke in the RUN position when the
EVO1000i has a warm engine.
read all information provided in this Owner’s
Manual.
5.
FIGURE 7: iency Mode Switch
6.
Turn the fuel valve to the ON position.
OFF
FUEL
1. Fill the fuel tank and check oil is to appropriate level.
NOTE:
The generator starts more easily with a full fuel tank.
2.
debris to prevent blocking the air intake vents in the
bottom of the generator.
ON
p/n 101592A
ON
FIGURE 8: Fuel Valve — ON position
7.
Press the engine control switch to the RUN position.
FIGURE 6: Air Intake - DO NOT BLOCK
FIGURE 9: Engine Control Switch
8.
EVO1000i Model Only: Turn the fuel cap vent to
the ON position.
FIGURE 10: Fuel Cap Vent — ON position
NOTICE
Blocking the air cause damage to the generator.
3.
Connect a ground wire to the generator (see
“Grounding the Generator” on p6).
11 www.evopower.co.uk EVO1000Si / EVO2000Si / EVO2000SEi / EVO3000Si / EVO3000SEi Inverter Generator Owner’s Manual
To Next Page
Loading...